Flat lid that can be opened by hand, with two handles on the front to lift it, and with a rubber gasket on the front edge. The boat is equipped with two handles fixed with screws on the sides. In addition, there are two sides obtained by pressure and two rear handles determined with ribs. The microchip slot obtained during printing is located at the bottom of the front of the boat. 1- Body and cover with guarantee certificate and certificate, each of which is printed in one piece with high density polyethylene (HDPE) injection method. 2-Fully recyclable, resistant to violet and infrared rays, acids and alkalis, high and low air temperatures. 3-DIN 30700 male attachment with printing grooves on the front edge of the container and no cutting edges or sharp corners. 4- Liquid discharge hole made of PEHD, with an impact resistant plug, on the underside of the container. 5-Four solid rubber wheels with a diameter of 200 mm that can rotate in all directions. The front wheels are each equipped with a pedal independent braking system. 6-Class 1 flanger striped container with red and white 'sergeant's wisp' pattern, in compliance with the laws in force (the decision of the Council of Ministers No. 1270/1985 and its amendments).